The ultimate all in one central vacuum rough-in kit so your home can have a central vac easily installed. If you're thinking about installing a built-in central vacuum cleaning system, then look no further! ZVac the makers of the best central vacuum cleaning systems on the market today bring you the all in one ZVac central vacuum installation kit.48 feet of pipe (12 pieces of pipe 4' long each) 2 -Sweep T 90's (for connecting the inlet pipe together) 3 - Short 90's (for backing plate of inlet) 6 - 45i fittings (for pipe installation) 9 - Long (sweep) 90's (for pipe installation) 6 - Pipe clamps (for holding the pipe up) 6 - Pipe couplings (for connecting pipe in a straight run) 3 - Inlet Backing plates (backing plates for mounting the central vacuum inlets to the wall studs) 3 - Standard Low Voltage Inlets (this is where you plug the central vacuum hose in to) 1 - Small bottle of glue (for gluing pipe together, be sure to apply glue to the outside of the pipe- then place in the fitting - try not to get glue inside the pipe itself where dirt travels) 1 - Bundle of low voltage wire (check local laws about requirements of low voltage gauge before installation!) This all in one central vacuum kit is enough to cover up to 1,800 sqft of a home (actual coverage size will vary depending upon home layout and locations of central vacuum inlets). This rough in kit by ZVac does not require oversize shipping rates as most others do! You can always buy more inlets and fittings if needed. This ZVac install kit uses standard central vacuum piping, fittings and inlets that are to ASTM F2158 standards.
This kit has 48 feet of pipe and is enough for standard 3 central vac inlets.
The Kit includes: